With the development of automation technology, the layer cages breeding model has been widely recognized by most layer farms. The breeding method occupies a small area and has a high space utilization rate. The layered cleaning of chicken manure can not only improve the utilization rate of chicken manure, but also reduce the degree of environmental pollution. It also improves productivity.
If only the roller is driven to rotate when cleaning manure, the manure conveyor belt will not move, which may be caused by excessive chicken manure. The excrement conveyor belt should be operated regularly, and the expansion bolts at both ends of the drive roller should be tightened to remove foreign objects. If the chicken manure on the manure belt is thin, it may be a leaking water dispenser, an imperfect seal of the water tank, and chicken diarrhea. It is necessary to replace the drinking fountain, apply a sealant to the joints, and use medicine for treatment.
If the material cart does not move, it may be that the driving wheel is rotating, the pull rope does not move, the positioning plate on the driven wheel does not touch the travel switch, the crawler wheel and the guide rail are squeezed, and the motor is damaged. At this time, it is necessary to rotate the ratchet of the paper feeder, tighten the rope, adjust the position of the travel switch to make it contact, correct the guide rail to make it parallel, and replace the motor.
If the egg breakage rate is high, it may be caused by the chicken pecking the eggs, the eggshell is thin, the claws on the automatic egg collector are broken, and the eggs rolling from the cage net collide with the eggs on the eggshell. It is caused by the automatic egg collector Come out, the egg collided with the egg on the middle egg line. You can use the electric shock cord to change the feed formula, find the broken claws and replace them, and use the egg block cord to adjust the height of the egg picker to make it cushion.
During the operation of the equipment, it is strictly forbidden to personally observe the operation status of the equipment and open the relevant inspection ports for maintenance. In the process of inspection, repair and maintenance, the staff must ensure that the main power switch is turned off and the main power switch is locked, otherwise it may cause serious injury. Two travel switches are installed at the head and tail of the machine, and the feeder guide wheel will stop running when it touches any travel switches. Regularly check whether the travel switch is sensitive, if it fails, please replace it in time, otherwise it will easily damage the paper feeder and even cause more serious consequences.