Because the temperature difference between autumn and winter is large, in order to give chickens of breeding machinery a warm and comfortable living environment for battery cage system design price in Uganda, so that the production performance of the flock can be better exerted, we must pay attention to control of temperature, humidity and ventilation.
The first is the temperature management of the chicken house. The temperature in the chicken house should be maintained at 18 ℃ ~ 23 ℃, and the minimum should not be lower than 15 ℃. Prevent wind from causing sudden drop in temperature in the house. Adjust the size of the air inlet every day according to the weather conditions and the performance of the flock.
Clean up the dust of the heater before the winter, and make the shutters parallel when the heater is first turned on, so that the hot air evenly fills the chicken coop. The door of the workshop and the hen house must be closed. Do not open at the same time to prevent cold wind from blowing directly into the hen house. Observe the flocks carefully every day. If the chickens are lying on the scaffold with their back hairs standing up, it means that the house is too cold. There is no chicken or few chickens on the scaffold at one end of the air inlet in the hen house, which means that it is cold here. You should adjust the air inlet or block the air leakage to prevent stress and prevent colds in chickens. Check the exhaust fan and motor before work every day to see if the temperature-controlled exhaust fan is sensitive. Watch the weather forecast every day in order to prevent it in advance.
Regarding the humidity management of the chicken house, you should add enough bedding before winter. In winter, the litter is relatively dry and should be sprayed with water or spray. If there is standing water under the scaffold, when the temperature is high in autumn, the water under the scaffold should be drained, and then sprinkled with white ash. When the temperature in the house is appropriate, increase the ventilation. Reduce the water pressure of the nipple drinking line to below 10 cm, or adjust the water level of the drinking fountain to below 1 cm. Check the drinking line frequently. The nipple connector of the drinking fountain should be replaced or repaired immediately. If the water leaks from the waterer, it should be handled in time to prevent the ammonia smell in the chicken house from being too large due to the water leakage, which will affect the health of the flock.
In autumn and winter, it is better to have fresh air and slow airflow in layer chicken cages price in nigeria. Repair the areas that should not be in the wind before winter, especially the air leakage at the exhaust fan must be handled to prevent the local chilled wind from making the overall poor ventilation of the chicken house and the low temperature near the exhaust fan, causing the chickens to get sick And affect production. When the ammonia smell in the house is high, the temperature in the house should be raised first, and then the ventilation should be increased. When comparing the air in the house in the morning, if it is necessary to increase the ventilation volume, it should be gradually increased, preferably at high noon temperature. It is better to use a shorter ventilation time and several passes. Do not leave dead ends when ventilating. If you want to increase the number of exhaust fans, you must be cautious, and carefully observe the performance of the flock after the increase, and then proceed without adverse reactions.